$255.00

Note: Only full case quantity of (6) 28 oz containers can be sent via ground shipping. (5 lb. container shown). Works with Fine or Coarse applications.

Out of stock
$255.00

28 gpm flow rate 2-3/4″ OD x 40″ Length

Base Price $255.00

When ordering a Fleck Control Valve, it is necessary for us to know the Height and Diameter of the tank the valve will be installed on. We will set the Fleck valve up to operate properly based on the size of the tank YOU specify for Tank Diameter and Tank Height. Please measure your tank [...]

$256.00

Motor Complete – Includes motor, switch, fuses, and motor shaft seal.

$258.00

HOT WATER Piston Assembly – Large Lower Piston Assembly for the Fleck 2900 and 2930 valves. (Will not work on the newer 2900s Valve). This is the NHWBP ( No Hard Water By Pass ) version, made for HOT WATER Applications. This NHWBP Piston DOES NOT allow any water to flow past the valve while [...]

Out of stock
$261.00

Packages include 1″ Brass Cross, Square D Standard Duty Pressure Switch (FSG2), 1/2″ Pressure Gauge, 1/2″ Boiler Drain, Stop & Waste Valve, Relief Valve and Brass Nipples. 1-1/4″ version for Well-X-Trol models WX205, WX250, WX251, WX252, WX255, WX302, WX350.

$263.00

Used on Fleck Models 9000, 9100 & 9500 Twin Tank Metered Assembly. The program meter wheel is located on the front and timer motor on back of this assembly. Has the standard range program wheel showing 125 – 2,100 gallons. Plz contact us if your Assembly has one of these a higher gallon range lables [...]

Out of stock
$264.00

21 gpm flow rate 2-3/4″ OD x 29-1/4″ Length

Out of stock
$264.00

24 gpm flow rate 2-3/4″ OD x 29-1/4″ Length

Out of stock
$264.00

30 gpm flow rate 2-3/4″ OD x 29-1/4″ Length

$265.00

(Riser tube not included). For 42″ tanks. 8 laterals.

$267.00

11 lbs total. For use in dry pellet chlorinators including Sentry, Land-O-Matic and Sentry Open Air Systems.

Out of stock
$269.00

The Sterilight S2Q-PA Ultraviolet Disinfection System is rated at 3 gpm.

Base Price $270.00

Fleck 5600 Specifications When ordering a Fleck Control Valve, it is necessary for us to know the Height and Diameter of the tank the valve will be installed on. We will set the Fleck valve up to operate properly based on the size of the tank YOU specify for Tank Diameter and Tank Height. Please [...]